Gate Mosfet WARFET v1.1 System

WARFET v1.1 MOSFET system engineered for AEG replica use. Among available electronic systems on the market, it stands out as the most sophisticated while remaining exceptionally user-friendly and straightforward to program. Controller installation requires no soldering, and there’s no need to modify the internals of your replica. Simply connect the system between your battery and the replica’s contacts for setup.

Weather resistance for the system is certified up to military standard MIL-V-173C, providing dependable performance even under the harshest field conditions. The kit is designed for seamless compatibility with Li-Po batteries, supporting voltages from 7.4 V up to 14.8 V. Integrated safety features protect against Li-Po battery over-discharge, safeguarding the battery from potential harm.

The system features programmable options
- pre-cocking—after each shot, the spring is compressed to minimize the interval between trigger pull and firing,
- active brake—this function engages an active brake to prevent excessive spring tension after a shot, reducing component wear,
- smart trigger—enables control over burst fire rate for shots fired in series,
- dark mode—disables the controller’s LED indicator that activates on trigger pull,
- burst time—permits adjustment of burst shooting duration,
- function for selecting fire selector configurations.

The package contains
- WARFET system,
- Mini Tamiya adapter for battery connection,
- Mini Tamiya adapter for replica connection,
- Deans-T connector set,
- single trigger contacts signal wire,
- double trigger contacts signal wire.

A programmer card—required for correct Power Module setup—is not included in the set.

Technical data
Power supply voltage range: 3-17 V
Short circuit protection: up to 1000 A
Standby current consumption: 0.2 mA
Resistance: 2 mΩ
Dimensions: 55 x 19 x 7 mm
Weight: 10 g
Manufacturer Gate, Poland