Universal durable gloves engineered to deliver essential mechanical protection. Designed for a secure, close fit, they offer optimal grip control without restricting precision in movement. Perfect for military personnel, law enforcement, shooting sport enthusiasts, as well as those involved in survival activities, vehicle maintenance, DIY tasks, and airsoft.
The upper section of the gloves is crafted from breathable, lightweight CoolPlus material, minimizing hand sweat and promoting excellent airflow. The rear side of the fingers features Rip-Stop fabric, engineered to resist tearing and fraying even after localized wear, and delivering enhanced abrasion resistance. For superior grip and control, the palm area utilizes durable 0.6 mm synthetic leather, which also enables touchscreen device operation without the need to remove the gloves. The critical zone around the thumb is reinforced by a Lock Ring panel, boosting structural durability and providing extra protection to the seams.
A broad stretch-elastic cuff delivers enhanced protection and ensures the gloves remain firmly in place on the wrist. The opening is generously sized, allowing for effortless donning. A 2-piece construction on the inner palm minimizes curling and bunching, resulting in an improved glove fit. The lower palm integrates ventilated padding, boosting airflow and providing extra protection against injury.
The gloves comply with the American safety standard ANSI/ISEA 105 at level 3XX for protection against cuts, abrasion, and punctures, defined as follows:
- 3: abrasion resistance (rated from 1 to 6)
- X: cut resistance (rated from A1 to A9)
- X: puncture resistance (rated from 0 to 5)
According to the EN388 standard, the gloves achieve protection level 2121X for resistance to mechanical hazards, meaning:
- 2: abrasion resistance (rated from 0 to 4)
- 1: cut resistance (rated from 0 to 5)
- 2: tear resistance (rated from 0 to 4)
- 1: puncture resistance (rated from 0 to 4)
- X: cut resistance – TDM method (ISO 13997) (rated from A to F)
Under the ANSI/ISEA 105 standard, abrasion resistance is evaluated on a scale ranging from 1 to 6 and reflects the number of cycles the material can endure before wear occurs. Cut resistance is measured on a scale from A1 to A9, indicating levels from minimal to maximum protection. Puncture resistance ranges from 0 to 5 and represents the force necessary to pierce the glove’s surface with a sharp probe (not applicable to needle puncture).
Protection levels in the EN388 standard use a scale in which 0 means no protection, while values of 4 or 5 denote the highest available durability.
The TDM test (ISO 13997) employs letter grades, with A standing for the lowest and F the highest protection level.
X indicates the specific property was either not examined or does not pertain.
