Versatile rugged gloves crafted to deliver essential mechanical protection. With their close-fitting design, they offer excellent grip control without restricting fine motor skills. Perfect for military and law enforcement professionals, shooting enthusiasts, survivalists, automotive repair, DIY tasks, and airsoft activities.
The upper section of the gloves utilizes breathable, lightweight CoolPlus fabric to minimize hand sweating and deliver excellent ventilation. The rear side of the fingers employs Rip-Stop material, which enhances resistance to tearing and fraying even if locally damaged, providing superior abrasion protection. The palm area incorporates robust, 0.6 mm thick synthetic leather that ensures a secure grip and precise control, while also enabling seamless operation of touchscreen devices without removing the gloves. The Lock Ring reinforcement shields the critical thumb area, boosting construction durability and helping to prevent seam damage.
A wide cuff equipped with a drawstring offers enhanced protection and ensures the gloves remain firmly secured at the wrist. The exceptionally wide opening allows for effortless donning of the gloves. Designed with a 2-piece inner palm, the gloves reduce bunching and curling for an improved fit. In the lower palm, ventilated padding increases airflow and delivers added protection against injury.
The gloves comply with the American safety standard ANSI/ISEA 105 at level 3XX, providing certified resistance to cuts, abrasion, and punctures, which indicates:
- 3: abrasion resistance (measured on a scale from 1 to 6)
- X: cut resistance (rated from A1 to A9)
- X: puncture resistance (evaluated from 0 to 5)
The gloves also fulfill the requirements of the EN388 standard at level 2121X for mechanical risk resistance, which is interpreted as:
- 2: abrasion resistance (scale of 0–4)
- 1: cut resistance (scale of 0–5)
- 2: tear resistance (scale of 0–4)
- 1: puncture resistance (scale of 0–4)
- X: cut resistance – TDM test (ISO 13997) (assessed from A–F)
Within the ANSI/ISEA 105 guidelines, abrasion resistance is rated on a scale from 1 to 6, signifying the number of cycles the material withstands before failure. Cut resistance ranges from A1 to A9, with protection increasing with the rating. Puncture resistance is classified from 0 to 5, reflecting the force necessary to penetrate the glove’s surface with a sharp probe (excluding needle puncture).
Protection levels specified by the EN388 standard indicate: 0 means no protection, whereas the maximum values (4, 5) reflect the highest available resistance.
For TDM testing (ISO 13997), letters represent the cut resistance, where A corresponds to the lowest, and F to the highest protective level.
The X symbol signifies that the respective test was either not conducted or not relevant.
